PDS:Zone Properties

1. Piece Properties of a Map Zone

2. Piece Properties of a Zone Piece

Pane Explanation

Zone Map

Create Piece From Map

Create all the pieces from the Map.

3.

4. Pieces were created. The Map Zone is deslected, and the new pieces are selected, for easy moving

Correct All Pieces By Map

If any of the pieces was changed, or if the map was changed - correct the Piece Zones according to the Map.

5. On the right – Map Zone; On the left – Zone Pieces

6. The Map Zone's geometry is changed

7. Click on the 'Correct All Pieces By Map'...

8. ...and all the relevant pieces were changed

Recreate All Internal Objects

All internal objects (circle, buttons, internal contour etc') from the Map Zone, are created on the Piece Zone (if not created automatically). If an internal contour goes along several zones, it will be created on the piece, and trimmed to fit it.

9.

10. Add several buttons along the Map Zone

11. Click on the 'Recreate All Internal Objects'

12. The buttons were copied to the Zone Piece, and also the internal contour of the Yoke was copied, and trimmed to fit the piece

Delete All Zones

All the zones are deleted from the select Map Zone. Notice, that Zone Pieces created

13. All zones are visible

14. Zones were deleted

Select All Zone Pieces

15. Map Zone is selected

16. After 'Select All Zone Pieces', all the pieces connected to it are also selected

Zone Action

This section appears under each zone. The Main and Sizes Information are the same as the ones in the 'regular' Piece Properties.

17. 'Zone Action' section, as it appears under one of the defined zones ('Zone1')

Disconnect

Remove the connection between the 'Map Zone' the 'Zone Piece'. Any change will no longer have an effect on each other. The zone will not be deleted from the Map Zone, but the 'Zone Piece Properties' will disappear from the properties pane of the Piece Zone. Disconnection can be used, for example, when wanting to close a dart, but without it to have an effect on the map.

18. The left piece is a Zone Piece

19. Only after 'Disconnecting' it, the dart should be closed...

20. ...and reshaped

Cutting Order

Cutting Order

Bring To Front/ Back

Change the Zones location in the Properties pane. This can be handy when wanting to see the zones according to their color.

21. 'Yoke' zone is in the back

22. After moving it forward, the Zone's color is shown

Related Subjects

• Piece Properties
• Zone