PDS:Create By Offsets
From OptiTexHelpEn
This command is used to create a a new Internal contour, according to an offset from the selected contour.
Contents |
Location
- Menu: Design> Create By Offsets
Operation
- Select a segment or a piece.
- Enter the required offset values for each point.
- You can extract a new pattern by using the Swap Segment Tool or the Build Piece Tool.
1.Select a Segment
2.Open the Create Internal Contour By Offsets window and enter the required values
3.
4.Select a pattern
5.Open the Create Internal Contour by Offsets window and enter the required values
6.
7.The final result
Active Cell
When a cell is deactivated its value is calculated automatically. Right-click on a cell to enable/disable it.
8.Arrow shows the affected area
9.Enter the required values
