PDS:Close Darts
From OptiTexHelpEn
Use this command to close darts that you wish to later re-open. This command is usually used to reshape a faulty contour line.
Location
Operation
- Select the required darts.
- Invoke the Close Darts command. The darts are closed.
1. Original pieces, the shoulder is not properly shaped
2. Close the dart
3. Move one of the points
4. Select the segment…
5. …and Guideline Through
6. Move the second point
7. Select the closed dart
9. Delete the grading point that was added when the dart was closed
10. The shoulder seam is reshaped, and the dart is in place
