Hardware:Numonics Digitizer

From OptiTexHelpEn

Numonics : ASCII
ASCII Options : CR, LF , Sep, Flag
Baud Rate : 9600
Data bits: 7
Parity: Even
Stop bits: 2
Modes : Point
Increment Size : 0 - Off
Stream Rate : MAX
Resolution : 1000 Per Inch or 40 Per MM
beeper : Enable
To Finish Press Save Configuration -> Application 1 , then Exit -> Confirm Changes

Open PDS , go to File menu >> Digitizer Setup
Choose Numonics from the list - this will bring all the communication setting, you can check if they are as describe in the picture bellow by clicking on the Communication Parameters button.

The COM port depends on you hardware configuration, Click here to see how to find the COM port installed on your computer
Numonics digitizer comes in two different size 36"X48" and 44"X60".

Troubleshooting

Place the cursor over the on the M mark (next to 1 and 2) located in the lower right corner of the tablet, just outside of the active area. With the cursor over this box, the tablet will emit a rapid series of beeps.
Depress and hold any button of the digitizer mouse on the bottom right of the digitize. The AccuGrid will now emit a solid tone. Continue to hold the cursor button until the tablet emits a single beep confirming activation of the softkey.
The AccuGrid will now emit a slow repetitive sequence of beeps. This is prompting to locate the menu origin of the Panel.
Place the cursor over the Menu Origin bulls-eye which is located at the bottom, middle of the setup menu just below the Numonics logo. With the cursor over the bulls-eye, depress and hold any cursor button down until the AccuGrid emits three quick beeps confirming the menu has been located.
You can now start to change the settings according to the yellow marks on the picture.
- When stepping over a setting with the cursor the led lights up
- When stepping over active setting the digitizer emits a beep.
- Make sure to load and save the settings.

Red arrow mark the orgin, Yellow mark the settings for optitex

Must be printed on a letter size paper