Hardware:Investronica P94 P200 and P2000

Investronica plotters works using Winpro and Plotwin Applications, After setting up the plot file setting and location in OptiTex, use the second section of this page to configuration Winpro and Plotwin.

Plotter Cutter Format Setup

Driver Format: HPGL

General Tab

X (Length): 180cm (70 inch) One Frame Only: checked Y (Width): 150-200cm (60-78 inch) Frame Advance After Last Frame: unchecked Y Offset: Optional Plot/Cut Piece in One Frame: checked Gap After Plotting: Optional Order According Tools: checked Minimal Plot/Cut Line: .008 Pens (Tools) According to Sizes: unchecked Bulge (Chord Error): 0.0079Inch or 0.02cm Plot Continuous: checked Overcut Length: Optional Splicing Marker Origin And Size : Optional

Device Tab

M19_For_Slit_Notch: unchecked (0,0) in Frame Center: unchecked M19 for Non-Slit Notch: unchecked Manual Frame Advance: unchecked Use Inch Unit: unchecked Use CR/LF in Code: unchecked Cut Darts: unchecked Use Initialization in File Header (<M70>/<IN>...): checked No Draw: checked Use Byte Offset: checked -> -.50 File Header: unchecked File Footer: unchecked Use Built-in Font: checked

Tools Setup Tab

No specific settings for the tools tab

---

Setings For Investronica Queue Manager

1. From Wintro program Investronica select the file Hpgl for creation queue of printing
   

   Create A New Queue
2. Close Wintro application and start the Plotwin program for driving plotter models P2000,P94 and P92
   

   Wintro Configuration

Wintro Configuration

Related Topics

• Investronica Hardware Connectivity