Hardware:Gerber Infinity Plotter

The Infinity plotter use a Gerber software called Winplot this software can browse HP-GL files, Generate HP-GL file from OptiTex to be saved on the computer disk . Then, from Gerber's "WinPlot" add the HP-GL file into the Infinity plotter's queue. Winplot software picks up the files and drives the plotter.

• Download Winplot here

Plotter Cutter Format Setup

Driver Format: HPGL

General Tab

X (Length): Obsolete (Must not be Zero) One Frame Only: checked Y (Width): 182(72inch) Frame Advance After Last Frame: unchecked Y Offset: Optional Plot/Cut Piece in One Frame: unchecked Gap After Plotting: Optional Order According Tools: unchecked Minimal Plot/Cut Line: 0 Pens (Tools) According to Sizes: unchecked Bulge (Chord Error): 0.0079Inch or 0.02cm Plot Continuous: checked Overcut Length: Optional Splicing Marker Origin And Size : Optional

Device Tab

M19_For_Slit_Notch: unchecked (0,0) in Frame Center: unchecked M19 for Non-Slit Notch: unchecked Manual Frame Advance: unchecked Use Inch Unit: unchecked Use CR/LF in Code: unchecked Cut Darts: unchecked Use Initialization in File Header (<M70>/<IN>...): unchecked No Draw: unchecked Use Byte Offset: unchecked File Header: unchecked File Footer: unchecked Use Built-in Font: checked

---