Hardware:Gamma Tech Jetlink

Setup The Gamma Tech Jetlink Plotter Control Programs

1. Install the Jetlink program from the CD that come with the plotter.
2. Open the Jetlink program when the installation completed.
3. From the Control menu , select File Source
4. Browase to locate the PLOTTER folder on your C drive ( create this folder if it is not exist) . click Ok

5. Click on the FILEMANGER button. Make sure that the FileExt are HPG and PLT.

Note: The Program has to be open when sending a plot file for the plotter.
The HPGL file will appear in the queue after generating it from the plot dialog box.

The file will start to plot automatically when the AutoPlot option is enable.

User Manual

Gammatech Jetlink H User Manual

For more information, please refer to the plotter user manual.

Plotter Cutter Format Setup

Driver Format: HPGL

General Tab

X (Length): Use the paper width.For a jetlink205: 205(CM) or 80" One Frame Only: Checked Y (Width): 3000 (CM) or 1180" (Inches ) Frame Advance After Last Frame: Checked Y Offset: Optional Plot/Cut Piece in One Frame: unchecked Gap After Plotting: Optional Order According Tools: unchecked Minimal Plot/Cut Line: 0 Pens (Tools) According to Sizes: unchecked Bulge (Chord Error): 0.0079Inch or 0.02cm Plot Continuous: checked Overcut Length: Optional Splicing Marker Origin And Size : Optional

Device Tab

M19_For_Slit_Notch: unchecked (0,0) in Frame Center: unchecked M19 for Non-Slit Notch: unchecked Manual Frame Advance: unchecked Use Inch Unit: unchecked Use CR/LF in Code: unchecked Cut Darts: unchecked Use Initialization in File Header (<M70>/<IN>...): unchecked No Draw: unchecked Use Byte Offset: unchecked File Header: unchecked File Footer: unchecked Use Built-in Font: Checked

---